Machifit MACH3 Z Axis CNC Tool Setting Touch Plate Engraving Machine Drilling Milling Tool

Using Method:

1. Connect the wire of this tool check insturment to the tool connector of your control board of the machine, then the control board's GND connect to the frame of
your router ( the frame of the router and the spindle must have connections)

 

2. Two ways to connect this item:

- If your interface board has the limit switch port or other probe port, you can connect it to that port

- If your interface board does not have that port, your driver board has that port,you can connect it to the driver board's limit switch port.

 

3. Then in the Mach 3, you need to setup the probe (Mach3 --- Config---Ports and Pins---Input signals Probe enabled, the pin number type the one you use) and the
Auto-Tool-Zero.in the attachment, it is the code, you can edit it as your requirements.

 

Note:

1. Red wire conect to the controller card adjusting-tool signal.

2. Black wire connect to the G on controller card.

3. When you connect feeler block well, and start device (not the spindle motor), please use clip click the surface of the feeler block, see if the Z axis will act or not.
If no problem, and connect the spindle motor by clip.

The color of the wire (black with red/ black with white) may send it in random.