110~220V 23W 8000L/H Wavemaker Aquarium Wave Maker for Wireless Water Pump with Controller

Specification:
1.Input Voltage:110V-220V 50/60Hz 1.0A
2.Output Voltage: 24V=1.0A
3.Flow Rate: 8000L/H
4.Power:23W
5.Color:Black

Package Included:
1 x Wave Maker Aquarium pump
1 x Intelligent controller
1 x Adapter(US Plug, a free adapter will be sent according to your country.)
1 x double-sided adhesive,
1 x manual

Feature:
1. The unique control system, a variety of wave model and function, can basically meet the user needs of the waveform;
2. Using the wireless linkage control to realize the synchronous operation between the pumps. It can be controlled by a lot and long distance control.
3. The use of low voltage DC frequency conversion pump ensures the safety of the user.
4. Simple operation panel to realize complex dynamic sea water function.
5. The direction of water flow can be adjusted according to the need.
6. Wide voltage input (AC110`220V 50/60Hz), can be suitable for a variety of power grids, and can avoid the effect of voltage fluctuation on wave making;
7. It is suitable for the size of all fish tanks, and the maximum glass thickness of the adsorbed fish tank is 15mm.

More details:
















Installation Instructions:
1. The pump body installation: take down the rear magnetic suction cup on the support of the wave pump body, and install the pump body in the middle of the inner wall of the fish tank. The inner wall of the cylinder is tightly sucked through a rubber sucker. Then the rear magnetic sucker is slanted to move to the outer wall of the cylinder. Because of the high magnetic force, be careful with the hand.
2. Remove the protective paper double-sided adhesive, close to the middle position behind the intelligent controller, then the other side of the double-sided adhesive protection paper, the controller attached to the tank side, as shown in Figure 1, convenient operation. If you don't have to install it on a fish tank, you can get rid of this step.
3. Connect the fast connection line with the 3 needle of the pump body and the controller, then connect the adapter's DC plug to the controller and connect the adapter AC line.